07/10/2018-16:49:07
RE: Altec 1505 - Suite en 3D
This is a printable Yuichi 1k horn.
The outer part is screwed to the inner parts with M6 cylinder head screws. The driver plate is screwed with M5 cylinder head screws. M6 screws are provided for the driver.
Original one is made of wood and designed by Yuichi Arai.
Refer to September 1991 issue of MJ Magazine, Tokyo for details.
A-1K Horn Specifications
= Horn Type : Hyperbolic horn
= Cut-off frequency : 900Hz
= Frequency range : 1200Hz to 20KHz
= Driver : 1 in or 2.5 cm throat Pioneer TAD 2001 or equivalent
# Print Settings
Printer Brand: Ultimaker
Printer: Ultimaker 2
Rafts: No
Supports: No
Resolution: 0.15mm
Infill: 18%
The outer part is screwed to the inner parts with M6 cylinder head screws. The driver plate is screwed with M5 cylinder head screws. M6 screws are provided for the driver.
Original one is made of wood and designed by Yuichi Arai.
Refer to September 1991 issue of MJ Magazine, Tokyo for details.
A-1K Horn Specifications
= Horn Type : Hyperbolic horn
= Cut-off frequency : 900Hz
= Frequency range : 1200Hz to 20KHz
= Driver : 1 in or 2.5 cm throat Pioneer TAD 2001 or equivalent
# Print Settings
Printer Brand: Ultimaker
Printer: Ultimaker 2
Rafts: No
Supports: No
Resolution: 0.15mm
Infill: 18%
@mitiés, GéBé.
Raspberry PI5B 8Giga / AlloDigit / Volumio / DAC SMSL SU-1 / Super 30 w Hiraga classe A / Enceintes Baffles Plans DIY 3 voies
Thorens TD160 SME III S + Shure V15 IV / Préamp ART DjPRE II / Super 30 w Hiraga classe A / Enceintes Baffles Plans DIY 3 voies
Raspberry PI5B 8Giga / AlloDigit / Volumio / DAC SMSL SU-1 / Super 30 w Hiraga classe A / Enceintes Baffles Plans DIY 3 voies
Thorens TD160 SME III S + Shure V15 IV / Préamp ART DjPRE II / Super 30 w Hiraga classe A / Enceintes Baffles Plans DIY 3 voies